Cookie settings

Vertical wrappers

Stretch Wrapping Turntable



Put the load on the turntable with a forklift or a pallet jack. Weigh and wrap loads in one step with a scale built into the turntable. With a Forklift stop, it helps the operator align the load on the turntable. Pallet grip usage is optional but it really helps as it makes a "cable" of film that locks the load to the pallet - the film cable decreases the risk of damage during shipment. Auto film cut-off automatically cuts the film at the end of the wrap cycle. This decreases labor on each load by approximately 30 seconds. Netting film delivery system applies stretchable and non-stretchable netting. This is for loads that have a requirement for ventilation. Note: This FDS cannot use the standard stretch films. Nema 12 enclosure keeps moisture, dust, and dirt from electrical components.


Technical specifications:

Peak production speed Up to 25-35 loads/hr
Load size diagonal (recommended) 1830 mm (72")
Maximum load wrap height 2030 mm (80")
Maximum load weight 1814 kg (4000 lbs)
Load Handling  
Turntable speed (variable) 12 RPM
Turntable size 1651 mm (65") diameter
Turntable drive 3/4 HP TEFC
Performance features  
XT cut and clamp Not available
Auto film cut-off Optional
Pallet grip Optional
Intelli-sensor Standard
Standard film width 500 mm (20")
EZ Thread film delivery Standard
Standard Pre - Stretch 200%
Wrap force Variable (electric)
Film capacity 250 mm (10") Roll diameter
Film delivery system Power Roller-Stretch
EZ Weight integrated scale Optional
Weight and size  
Approximate shipping weight 658 kg (1450 lb)
Size 3023 L, 1702 W, 2337 H (mm)
Service requirements  
Pneumatic Not Applicable
Dedicated electric service required 220 VAC 16 Amp